Thomas J. MacDonald
Get Your Rough Cut DVDs and Plans!
It is currently Fri May 24, 13 1:37 pm View active topics

Board index » Workshop Equipment

All times are UTC - 5 hours

A minor tool gloat

Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
tiny
 PostPosted: Sun Nov 21, 10 6:27 am   
Bench Dog
User avatar

Joined: Fri Feb 26, 10 5:26 pm
Posts: 1147
Location: Winnipeg, Manitoba, Canada
Greetings all.

I got a pretty good deal this week off our local Kijiji buy/sell web site. A 6 inch Vermont American stacked dado set in like new shape for only $15.

How could I pass it up? I didn't have a set and wanted one, but couldn't justify the expense for the use I'd get out of it, so this was the answer to my prayers.

Sometimes it pays to check these sites out every now and then, eh? :D

Paul
the lucky little guy
Top
 Profile  
swedishiron
 PostPosted: Sun Nov 21, 10 12:03 pm   
Bench Dog
User avatar

Joined: Sat Jun 21, 08 1:37 am
Posts: 603
Location: Longmont, Colorado
tiny,
Nice find fore sure. I look over the craigslist ads everyday, sometimes multiple times and its all worth when you get a deal such as yours. All the power tools in my shop were purchased this way. Besides most of the fun is the hunt and thrill that goes along with knowing you're the first one to call/email about the item.

_________________
- Scott
"Honey, I said I don't need more lumber, I didn't say I won't buy more."

Top
 Profile WWW YIM  
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 


Forum rules
By using this forum and/or its affiliated web sites, you are agreeing that under no circumstances will the owners, moderators, its affiliates, or any other member listed on this site be responsible for (1) any information contained on or omitted from the site(s), (2) any person's reliance on any such information, whether or not the information is correct, current or complete, (3) the consequences of any action you or any other person takes or fails to take, whether or not based on information provided by or as a result of the use of the sites. 207 Woodworking, 207 Forum, Thomas J. MacDonald Fine Furniture, Inc. and their affiliates also have no responsibility for (4) any person's satisfaction or use/misuse of any information or advice obtained through these sites.

The Owner and Moderators of this site do not attest to the veracity of, nor accept any liability for, the opinions or suggestions posted by any individuals on either site. When using tools, equipment or chemicals, one should always read, understand and follow the manufacturer's instructions for proper use and disposal.

Board index » Workshop Equipment

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: