I was inspired to use MDF to carve a number of different patterns. They were sanded and painted. These can now be used for cabinetry facades, entry doors or simple wall panels. In between each panel, there are standards that allow shelving.
Attachments:
d746a63fb9251e76d28b08732ca96b18_large.jpg [ 270.54 KiB | Viewed 554 times ]
0cefdf0183c6bc862e72c6bc85828d25_large.jpg [ 181.66 KiB | Viewed 554 times ]
956baa402c9979740c3d3d410c78384c_large.jpg [ 281.25 KiB | Viewed 554 times ]
094a07c262d8c7f24f1bfd83bad7f314_large.jpg [ 156.31 KiB | Viewed 554 times ]
7ed59f8ed50e6abe8acace56e35a1fbd_large.jpg [ 148.71 KiB | Viewed 554 times ]
76e3ca948cb88fbad90550670f991e1d_large.jpg [ 155.13 KiB | Viewed 554 times ]
Joined: Wed Mar 02, 11 1:15 pm Posts: 446 Location: New york
Oh yeah that's me all the way..... If your marketing these let me know.
Very nice.
The standard your using is it similar to a mud-in-standard? meaning, a standard that is sandwiched between two pieces of sheet rock with j-channel on both sides of the standard?
_________________ "Leave the gun take the cannoli"
Some of them were CNC, the others were done by hand. Yes, these panels have a mud-in-standard. I am marketing them and fully capable of mass producing.
Forum rules
By using this forum and/or its affiliated web sites, you are agreeing that under no circumstances will the owners, moderators, its affiliates, or any other member listed on this site be responsible for (1) any information contained on or omitted from the site(s), (2) any person's reliance on any such information, whether or not the information is correct, current or complete, (3) the consequences of any action you or any other person takes or fails to take, whether or not based on information provided by or as a result of the use of the sites. 207 Woodworking, 207 Forum, Thomas J. MacDonald Fine Furniture, Inc. and their affiliates also have no responsibility for (4) any person's satisfaction or use/misuse of any information or advice obtained through these sites.
The Owner and Moderators of this site do not attest to the veracity of, nor accept any liability for, the opinions or suggestions posted by any individuals on either site. When using tools, equipment or chemicals, one should always read, understand and follow the manufacturer's instructions for proper use and disposal.
Users browsing this forum: No registered users and 1 guest
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
