Thomas J. MacDonald
Get Your Rough Cut DVDs and Plans!
It is currently Fri Aug 01, 14 5:26 pm View active topics

All times are UTC - 5 hours

Catching up on project pictures


Post new topic Reply to topic  [ 2 posts ] 
Author Message
 PostPosted: Sun Jan 22, 12 7:09 pm   
Lumber Ruler

Joined: Sat Dec 20, 08 8:33 pm
Posts: 44
Location: Norwalk, Ohio
Amazing how life can get in the way.


Attachments:
File comment: Red Oak book case
006.JPG
006.JPG [ 1.64 MiB | Viewed 567 times ]
File comment: Red Oak book case
008.JPG
008.JPG [ 1.97 MiB | Viewed 567 times ]
File comment: Red Oak book case
010.JPG
010.JPG [ 1.86 MiB | Viewed 565 times ]

_________________
Andrew Betschman

http://andrewmbetschman.com/
Top
 Profile WWW  
 PostPosted: Mon Jan 30, 12 4:29 pm   
Lumber Ruler

Joined: Sat Dec 20, 08 8:33 pm
Posts: 44
Location: Norwalk, Ohio
Wormy Maple. The finish is tung oil, gloss lacquer and wax. Still trying to decide plain glass, mirror or stain glass


Attachments:
002.JPG
002.JPG [ 1.46 MiB | Viewed 488 times ]

_________________
Andrew Betschman

http://andrewmbetschman.com/
Top
 Profile WWW  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 


Forum rules
By using this forum and/or its affiliated web sites, you are agreeing that under no circumstances will the owners, moderators, its affiliates, or any other member listed on this site be responsible for (1) any information contained on or omitted from the site(s), (2) any person's reliance on any such information, whether or not the information is correct, current or complete, (3) the consequences of any action you or any other person takes or fails to take, whether or not based on information provided by or as a result of the use of the sites. 207 Woodworking, 207 Forum, Thomas J. MacDonald Fine Furniture, Inc. and their affiliates also have no responsibility for (4) any person's satisfaction or use/misuse of any information or advice obtained through these sites.

The Owner and Moderators of this site do not attest to the veracity of, nor accept any liability for, the opinions or suggestions posted by any individuals on either site. When using tools, equipment or chemicals, one should always read, understand and follow the manufacturer's instructions for proper use and disposal.

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: