i have noticed that the left draw runner is out of square and lifts up around 1/16 - 1/8 on a distance of 8 inches. i did not sight the draw front but what can i do to fix this and what type of things can i run into for the rest of the draws
Hey Falcon, not sure what your saying here, as I read it, you have a seperate runner on the drawer. If so is the runner attached to the case and the drawer dado'd If thats the case very slight measurement differences can compound rapidly even in 8"
Or are you saying the left side of the drawer is out of square and lifts that amount? First question that comes to my mind is were the ends of the boards square to start with? Is the front slightly twisted? Or is the drawer actually racking?
Hard to discern without pictures, or I am missing something. Can you pull the drawer square with light clamp pressure? Not glued that is.