Thomas J. MacDonald
Get Your Rough Cut DVDs and Plans!
It is currently Sat Nov 01, 14 12:14 am View active topics

All times are UTC - 5 hours

Oscillating Spindle Attachment for a Drill Press


Post new topic Reply to topic  [ 3 posts ] 
Author Message
 PostPosted: Mon Mar 26, 12 2:14 pm   
Spectator

Joined: Mon Mar 26, 12 2:10 pm
Posts: 1
Do you know if there is an attachment that I can put on my drill press to make it an “oscillating” spindle sander?

Thanks!


Top
 Profile  
 PostPosted: Sat Mar 31, 12 9:42 am   
Bench Dog

Joined: Sat Oct 16, 10 9:11 am
Posts: 484
Location: Racine, WI
Haven't heard of that one. But I would think by the time you purchase the assembly that will allow it to oscillate up and down, it would be far cheaper to buy a table oscillating sander.

Just my 2 cents worth.

_________________
Richard

You will never know what your capabable of until you try.


Top
 Profile  
 PostPosted: Sat Mar 31, 12 11:54 pm   
Bench Dog

Joined: Sat Jan 31, 09 3:23 pm
Posts: 710
Location: 20 miles west of boston
I ended up getting one of those rigid table top units off craigslist for under 100$

_________________
Eastern Mass guild of Woodworkers. http://www.emgw.org/

As the sun pulls away from the shore, and our boat sinks slowly in the west...


Top
 Profile YIM  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 


All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 0 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron